MagnaSlot 75 » Electro Permanent Magnetic Chuck - 75 mm Pole
EPM 1000x2000 chuck. Entered into LIMCA BOOK OF RECORDS, INDIA as the LARGEST ELECTRO PERMANENT MAGNETIC CHUCK MADE. published in 2009 edition under Business Chapter.
EPM chuck on a Milling machine
EPSQUARE75 - 500x500 Chuck with an arrangement of Fixed and Spring Blocks
EPSQUARE75 - 600x2000
Electro Permanent Magnetic Chuck being used on a conventional milling machine for gang milling
Electro Permanent Magnetic Chuck used for cutting 45 Deg on a steel Block
Facing Operation undergoing on a job clamped using Magnets. Note: the chips does not come in way of the moving cutter
Block machining on a VMC while the job is clamped magnetically using Electro Permanent Magnetic chuck
Electro Permanent Magnetic Chuck used for grinding operation
Electro Permanent Magnetic Chuck used to Machining of a rough block in a Horizontal Machine
THrough Drilling operation on a VMC. Note: the job is raised above the chuck using pole extensions, so that the through drill does not damage the Electro Permanent Magnetic chuck.
a conventional vice clamped on a Electro Permanent Magnetic Chuck
EPSQUARE75 - 600X1500
a 6000x2500 mm plate, used for drilling on a VMC. the solution has 4 numbers of EPSQUARE75-300x400
Electro Permanent Magnetic with Special V Profile made to clamp the round job.
Electro Permanent Magnetic Chuck with special V Profile
Electro Permanent Magnetic Chuck with Special V Profile made to clamp the round job.
EPM Chuck used to clamp a die on a Horizontal Machining Centre
